Grandfather Clock Moon Dial Ordering

Posted on    Posted in  turned_in_not  Clock Dials

Grandfather Clock Moon Dial Ordering

Before ordering the new moon dial for the grandfather clock, this section must be read. Not all moon dials fit all clocks, each one is made for a specific clock movement. The reason is most moon dials have four feet, or posts, that stick out the back of the dial. These feet have to lock into the movement its being attached too. If the feet are in different locations, it will not lock into the movement. They must be married together so to speak. These grandfather clock moon dials are for post WW2 clocks only.

How to get the right moon dial

To get the correct moon dial for your clock, you will need the movement numbers. This will be directly off of the back plate of the movement itself. It will not be on any of the paperwork that came with the clock, or on the wood case. Movement numbers can only be found on the clockworks itself. With the movement numbers you can match up the number with the numbers posted on the moon dial description.

What has to match

  • The posts on the back of the dial need to lock into the movement. A hand shaft that is long on the movement, will require longer posts. In other words, the posts on the back of the dial make it so the hand shaft will stick out far enough to put the clock hands on.
  • If the movement is cable driven, the holes to wind the clock need to be in the right spot. This is important for when you put the key crank in. If it is aligned correctly, it will go onto the winding arbor of the movement. When it is not aligned properly, winding will be difficult or impossible.

  • Some clocks have a second hand bit which also has to be perfectly aligned. This goes onto the small post coming off of the escape wheel. The second hand is a friction fit.

On a chain driven unit, it is possible to get any moon dial and remove the feet off the clock dial. The dial would then have to be attached to the wood case instead. Because there are no winding arbors on a chain driven unit there are no holes in the dial to line up. There is also rarely a second hand bit. So you could use any dial with no winding holes and attach it to the wood case. However, one thing to mention is that the moon phase will most likely no longer spin.

The content of this website is copyright by Clockworks and written by James Stoudenmire

↑ Back to top

Ask a Clock Question

Shop By Brand

Shop Hermle

Find the perfect Hermle movement for your clock.

Howard Miller

Find the perfect Howard Miller movement for your clock.

Shop Kieninger

Find the perfect Kieninger movement for your clock.

Seth Thomas

Find the perfect Seth Thomas movement for your clock.

Shop Urgos

Find the perfect Urgos movement for your clock.

Ridgeway Clocks

Find the perfect Ridgeway movement for your clock.