132-071 clock movement installation

Posted on    Posted in  turned_in_not  130 / 131 Series

132-071 Clock Movement Installation

132-071 Clock Movement Installation instructions for a new 132-071 clock movement that you purchased from Clockworks.com.

Remove the hands

Remove the minute hand by taking off the hand nut. Use a pair of needle nose pliers to gently turn the nut to the left. Once it is loosened, you will be able to remove it with your fingers. Once the hand nut is off, the minute hand will easily come off. The hour hand is a friction fit. Twisting it back and forth while pulling toward you at the same time will remove the hour hand. Although you may not be able to tell, the hour hand tube is tapered wider as it goes into the movement. This means the more the hour hand is pressed down onto this post, the tighter it will be. It will also be harder to come off.

Remove mounting screws

Use a flat head screwdriver to remove the screws. There are usually four screws at the 12 - 3 - 6 and 9 o’clock positions. Sometimes, there are also screws on the back of the clock case. These need to be removed so the entire movement, and the dial, can come out the front. These are a couple of different mounting methods you may encounter.

Take off the clock dial

The dial is usually attached to a metal plate. This metal plate will have three or four posts that go into the clock movement. The dial comes off of the metal plate with three or four small flat screws. The metal plate that the dial is attached to comes off by releasing the posts that go into the movement. The posts that go into the movement will come off by one of two ways. The first being that the post may have a tapered pin holding it. This means a pin that is fat on one side and skinny on the other. The skinny side will be stuck into a hole drilled into the post. To remove the pin, grab it with a pair of needle nose pliers and yank it out.

The other instance you will encounter is a locking collar. The locking collar will have a set screw that needs to be loosened for it to come off. With the posts released from the movement, the dial will come straight forward and off of the movement.

Installing the new movement

Installation is the reversal of the removal process. The first step is to put the metal plate with the posts back on the clock movement with its tapered pins or set screws. Install the movement with its metal dial plate into the round metal clock case and reattach. Install the clock dial back onto its metal holding plate. Put the hour hand on the clock as a friction fit and then the minute hand with its nut.

Set the chime with time

After the new movement is installed, you will notice the clock will chime 5 minutes before the hour or after the hour, or 8 minutes, or whatever. The idea being that it won’t chime when it’s supposed to.

Take the minute hand off of the clock. This is the longer of the two hands. With this minute hand off of the clock, turn it upside down. You will see it has a square hole where it attaches to the clock. This square hole is in a bushing that will rotate WITHIN the minute hand itself.

Grab that bushing with needle nose pliers and rotate the bushing a little bit. Then put the hand back on the clock and see if it’s pointing to the correct place where it chimed. If it is, then set to time. If it isn't, take the minute hand off again and rotate the bushing some more. Keep doing this until you get it to point to where the clock just chimed. Then set it to the correct time. This concludes the 132-071 Installation Instructions.

The content of this website is copyright by Clockworks and written by James Stoudenmire

↑ Back to top

Ask a Clock Question

Shop By Brand

Shop Hermle

Find the perfect Hermle movement for your clock.

Howard Miller

Find the perfect Howard Miller movement for your clock.

Shop Kieninger

Find the perfect Kieninger movement for your clock.

Seth Thomas

Find the perfect Seth Thomas movement for your clock.

Shop Urgos

Find the perfect Urgos movement for your clock.

Ridgeway Clocks

Find the perfect Ridgeway movement for your clock.